How this calculation works
Ohm’s law relates voltage, current and resistance for a component whose resistance is constant under the conditions being considered. Current in amperes multiplied by resistance in ohms gives volts. Select any of the six known pairs; the field order and units follow the selected pair. Non-IR pairs need positive inputs to avoid undefined zero cases.
V=IR; P=VI=I²R=V²/RA worked example
A current of 2 A through 10 Ω corresponds to 20 V.
Good to know
An ideal DC relationship. Real components may change resistance with temperature or behave nonlinearly. Not an electrical installation design tool.
The same resistance turns current into a voltage drop
Across a fixed 10 Ω resistor, 1 A corresponds to 10 V and 2 A to 20 V. The proportional relationship holds because resistance is kept constant. Changing the material or its conditions can change that resistance and therefore the relationship.
Combining V = IR with P = VI gives P = I²R for this ideal resistive model. Doubling current at fixed resistance doubles voltage but quadruples dissipated power. The LED series resistor calculator first subtracts the assumed string drop before applying the resistor relationship.
Electrical power in the matching DC model can then be checked using P = VI. Keep the voltage and current tied to the same component.
Convert milliamps before multiplying
1,000 mA equals 1 A. If a current is 20 mA, enter 0.02 A, not 20. Paired with 100 Ω, that gives 2 V. A prefix error would change the answer by a factor of one thousand.
Use this for an ideal DC resistance calculation. Components with nonlinear behavior, changing temperature or reactive AC impedance need additional models. The arithmetic does not determine a safe component power rating.
Six known pairs lead to the same ideal resistive quantities
Voltage, current, resistance and power are related by V=IR and P=VI. With a suitable positive pair, the remaining quantities follow. For power and resistance, the square root appears because P=I²R. The selected dropdown states the first and second input units explicitly, so a power value is not silently interpreted as current.
The current/resistance pair retains the original voltage calculation and allows zero magnitudes. Other pairs require positive values here because several zero combinations leave resistance or current undefined. For example, zero voltage and zero current do not determine a unique resistance. The engine reports the supported model rather than dividing by zero.
A straight line describes an ohmic model
The voltage-versus-current graph holds the calculated resistance fixed. Its slope is resistance in ohms. That does not mean a diode, lamp filament or motor necessarily follows the same line across its whole operating range. The LED series resistor calculator explicitly separates a fixed diode-drop assumption from the resistor’s voltage headroom.
The voltage drop calculator applies a resistive approximation to a two-conductor path. It still needs material, distance and conductor area assumptions beyond Ohm’s law alone. Neither page establishes ampacity, protective-device selection or compliance with wiring rules. Keep calculated dissipation separate from a component’s rated capability.
A few questions, answered
Does this solve for current or resistance?
This edition calculates voltage from current and resistance.
Can I use a resistance quoted in kΩ?
Convert it to ohms first: 1 kΩ equals 1,000 Ω.
Why is there a square root for power and resistance?
Solving P=I²R for nonnegative current gives I=√(P/R).
Does an AC load always obey this four-number model?
No. Reactance and power factor require a more complete model.
Are calculated watts a selected power rating?
No. Dissipation and a suitable component rating are different questions.