Shapes & spaces

Spherical zone surface area calculator

Find the curved surface between two parallel planes intersecting a sphere.

Your numbers

Calculated on your device. Your inputs aren’t sent to us.

Your result

Ready when you are

Enter your inputs and select Calculate.

Report an issue

Behind the numbers

How this calculation works

For a fixed sphere radius, moving the zone along the sphere leaves its area unchanged as long as the height stays the same.

THE FORMULAA = 2πRh

A worked example

A zone 3 units high on a radius-5 sphere has area 30π.

Good to know

Zone height may be at most the sphere diameter.

Use the zone’s vertical height rather than its curved width

A spherical zone is the curved band between two parallel planes cutting a sphere. Its surface area is A = 2πRh, where R is the sphere radius and h is the perpendicular distance between the planes. For R = 5 and h = 3, the band area is 30π, approximately 94.24778 square units.

The SVG shades a band and places its height marker vertically between the cutting planes. The visible arc distance from one boundary circle to the other is longer than that vertical separation and must not be entered as h.

A spherical band is bounded by parallel cuts separated vertically by three unitsR = 5h = 3Curved band area = 30π
For sphere radius 5 and vertical zone height 3, curved surface area is 2π × 5 × 3 = 30π. Diagram is schematic.

Explain why the position of a band does not change its area

At vertical coordinate z, a sphere has horizontal radius ρ = √(R² − z²). A thin meridian strip has sloping length ds = R dz/ρ. Multiplying its circumference 2πρ by ds cancels ρ, leaving dA = 2πR dz. Integrating across a vertical interval of height h gives the zone formula.

Consequently two bands with the same vertical height on the same sphere have equal curved area, even if one lies near a pole. At h = 2R the formula gives the full sphere area 4πR². The Cone frustum slant height from lateral area calculator contrasts a surface where slant length enters directly. This output excludes the planar circular cuts and requires h no greater than the diameter. Lengths must use the same unit, and scaling both by k multiplies area by k².

A few questions, answered

Does this include the flat circular ends?

No. It gives only the curved spherical surface between the planes.

Can I use the same formula for a spherical cap?

Yes. A cap is the zone extending from one cutting plane to a pole, with h measured vertically from that plane to the pole.

Find your calculator

Start typing to explore the library.