How this calculation works
If the known measurement is a diameter, halve it before evaluating πr². The circumference is 2πr or πd. Radius and diameter are linear dimensions, while area is measured in squared units. The zero-size case has zero area and circumference.
Area = πr²; circumference = 2πrA worked example
A radius of 5 units gives an area of approximately 78.539816 square units.
Good to know
A flat circular region only, with one consistent length unit. Enter either radius or diameter as selected, not a mixture of both. The calculation does not infer a circle from an irregular measured outline. Decimal π results are rounded.
Diameter spans both radii
A ring torus calculator revolves a circular cross-section around an external axis to form a three-dimensional ring. Its surface area and volume are different quantities from the area enclosed by a flat circle.
The regular polygon calculator works with a straight-sided boundary and distinguishes circumradius from apothem. The annular sector calculator instead tracks a partial angular region and its exposed boundaries.
The ellipse area and perimeter calculator uses two semiaxes. A circle is the equal-semiaxis special case, while an ellipse needs a different perimeter calculation.
A diameter goes through the centre from one side of a circle to the opposite side. It is twice the radius. If the entered measurement is a diameter, halve it before squaring a radius for the area calculation. Substituting the whole diameter as the radius would multiply the resulting area by four.
For a diameter of ten units, the radius is five, area is 25π square units and circumference is 10π units. Selecting radius five produces exactly the same mathematical circle. The input mode makes that interpretation explicit rather than asking a user to guess which length a field expects.
A circumference and an area scale differently
Doubling the radius doubles the circumference because it is a linear relationship. The area becomes four times as large because the radius is squared. Keep the unit label: square centimetres and centimetres do not describe the same kind of measurement.
The circular sector calculator models only a stated angular portion or annular region. This full-circle page assumes an entire flat disk. A real measured outline that is not circular should not be forced into the model by choosing a single convenient width.
A few questions, answered
Can I enter the diameter directly?
Yes. Select Diameter as the known measurement; the radius is then calculated internally.
Why does doubling the diameter quadruple area?
The radius also doubles, and area depends on its square.
Does circumference use square units?
No. It is a boundary length and uses the original linear length unit.