Shapes & spaces

Cone frustum slant height from lateral area calculator

Recover the slant height and vertical height of a cone frustum from its lateral area.

Your numbers

Calculated on your device. Your inputs aren’t sent to us.

Your result

Ready when you are

Enter your inputs and select Calculate.

Report an issue

Behind the numbers

How this calculation works

When the slant equals the difference of radii, the vertical height vanishes. A positive-height frustum requires a larger slant.

THE FORMULAℓ = A/[π(R+r)]

A worked example

Radii 5 and 2 with lateral area 35π give slant height 5 and height 4.

Good to know

Use lateral area only. It excludes both circular ends.

Recover the sloping side from the lateral area

For a right circular cone frustum with parallel radii R and r, lateral area is A = π(R + r)ℓ. Dividing by π(R + r) gives the slant height ℓ. The defaults R = 5, r = 2 and A = 35π yield ℓ = 5.

An axial cross-section contains a right triangle whose horizontal leg is the radius difference |R − r|, vertical leg is h and hypotenuse is ℓ. Here the difference is 3, so h = √(25 − 9) = 4. The diagram marks this 3–4–5 triangle inside the frustum cross-section.

A three-four-five right triangle connects radius difference, vertical height and slant heightr = 2h = 4ℓ = 5R − r = 3
For R = 5, r = 2 and lateral area 35π, slant height is 5 and vertical height is 4.

Separate curved area from the two circular ends

The entered area must exclude both ends. Total surface area would be A + πR² + πr². In the example that is 35π + 25π + 4π = 64π. Using 64π as the lateral-area input would overestimate both slant and vertical heights.

A positive-height frustum requires ℓ > |R − r|. Equality gives zero vertical height, while a smaller slant height cannot span the radius difference. The calculator rejects both cases. Swapping the two radii preserves the outputs. If they are equal, the shape is a cylinder and slant height equals vertical height. The Regular tetrahedron from edge length calculator provides another example where an outer edge differs from a perpendicular internal height. Use square units for area consistent with the radii’s length unit.

A few questions, answered

Does this apply to an oblique frustum?

The formulas assume a right circular frustum with coaxial circular bases. An oblique shape needs additional geometry.

Can I enter a zero top radius?

This tool requires positive radii. A zero top radius gives the cone limit, which can be calculated with cone formulas.

Find your calculator

Start typing to explore the library.