Unit converters

Length converter

Convert length between commonly used units with the measurement system clearly identified.

Your numbers

Calculated on your device. Your inputs aren’t sent to us.

Your result

Ready when you are

Enter your inputs and select Calculate.

Report an issue

Behind the numbers

How this calculation works

Both units are mapped to a shared base unit using fixed conversion factors. US and imperial volume units are distinct; area factors are squared length factors.

THE FORMULAConverted value = value × source factor ÷ destination factor

A worked example

1 metres = approximately 3.280839895013 feet.

Good to know

Results use fixed factors and rounded decimal display. Region-specific land measures and fluid/dry units not listed here are not inferred.

A little curiosity

The object stays the same when the number changes

The height converter accepts whole feet plus inches, or whole metres plus centimetres, when your measurement is written in split units rather than a single decimal value.

A metre and about 3.28084 feet describe the same length. The bigger numerical value does not indicate a larger object: the foot is a smaller unit, so more of those units fit along the same distance.

Unit conversion is multiplication by a ratio equal to one. Writing the units as fractions helps check the direction: metres × feet/metre leaves feet. If the unwanted unit does not cancel, the factor is probably upside down.

The CSS unit converter handles px, rem and em using supplied font references. These are CSS layout units and should not be confused with the physical length conversions on this page.

An area converter uses squared length factors. A length conversion factor cannot be applied unchanged to square measurements.

Decimal feet are not feet and inches

A displayed 5.5 ft means five and a half feet, which is 5 ft 6 in. It does not mean 5 ft 5 in. Convert the decimal fraction of a foot by multiplying it by 12 to obtain inches.

The listed foot and mile are based on the international foot. Survey records can use a differently defined historical unit, so identify the source standard rather than assuming every document’s “foot” is interchangeable.

A few questions, answered

Can I enter feet and inches in one field?

No. Convert them to decimal feet, such as 5 + 6/12 = 5.5, before entering the value.

Why do some conversions show many decimals?

A simple value in one unit need not have a terminating decimal representation in another. The display is rounded.

Find your calculator

Start typing to explore the library.